Ball screws are the core transmission components of precision machinery. Its reliable operation is essential. Understanding common faults and troubleshooting ideas can help you quickly solve problems and reduce downtime.

  • Abnormal noise or vibration

    Possible causes: Insufficient lubrication, foreign matter intrusion, bearing damage, ball screws or nut wear, improper installation (such as misalignment).

    Troubleshooting steps: First, check the lubrication status and add or replace the specified lubricant. Second, thoroughly clean the screw, nut and guide rail to remove impurities. Next, check the bearing status and confirm the wear of the screw/nut. Finally, review the installation accuracy to ensure that the supports at both ends of the screw are concentric and parallel to the guide rail.

  • Operation jam or excessive resistance

    Possible causes: Lubrication failure, foreign matter jamming, screw bending, ball damage or missing inside the nut, excessive preload.

    Troubleshooting steps: First, check and restore effective lubrication. Second, clean thoroughly. Then, check the screw straightness. In addition, check whether there are damaged balls or cracked retainers inside the nut. Finally, confirm whether the preload setting is appropriate.

  • Overheating

    Possible causes: Poor or excessive lubrication, excessive preload, overspeed operation, excessive load, insufficient cooling.

    Troubleshooting steps: First, check the type, amount and state of the lubricant. Second, confirm whether the preload value is within the recommended range. Next, evaluate whether the operating speed and load meet the design specifications. Finally, check whether the heat dissipation environment is good.

  • Positioning accuracy decreases or reverse clearance is too large

    Possible causes: Preload loss due to nut wear, support bearing wear or looseness, coupling looseness, insufficient system rigidity.

    Troubleshooting steps: First, check whether the preload of the nut is attenuated. Second, check and tighten the support bearing. Next, confirm that the coupling between the motor and the screw is firmly connected. Finally, evaluate the rigidity of the entire transmission system.

  • Screw nut is obviously loose

    Possible causes: Loose fastening screws, failure of anti-loosening device, wear of related mounting surfaces.

    Troubleshooting steps: Check and tighten all nut mounting screws immediately. At the same time, confirm whether the anti-loosening washers and other devices are effective. In addition, check whether the nut seat and related mounting contact surfaces are worn and deformed.

ball screws
Systematic troubleshooting principle

Safety first: Be sure to cut off the power source before troubleshooting.

From outside to inside: Prioritize external factors such as lubrication, cleanliness, and installation and tightening.

Observation and analysis: Pay attention to the phenomenon (sound, location, temperature) when the fault occurs.

Record tracking: Record maintenance and replacement in detail for easy tracking.

Regular preventive maintenance of ball screws (cleaning, lubrication, inspection) is the key to reducing failures! If you encounter complex problems or need to replace core components (such as screws and nuts), it is recommended to seek professional repair services.